airbus-catia-v5-part-design.pdf

节选段落一：
3 of 90 Issue 1
ANS-UG0300110
Contents
Session 4 – The Part Design Workbench.................................4
An Introduction to Part Design ................................................................................. 5
Accessing the Part Design Workbench ......................................


节选段落二：
AIRBUS UK CATIA V5 Foundation Course
DMS42184 Page 5 of 90 Issue 1
ANS-UG0300110
An Introduction to Part Design
The Part Design Workbench is used to create Solid geometry using a Feature based
approach. In general the features are produced from sketches created in the Sketcher
workbench.


节选段落三：
AIRBUS UK CATIA V5 Foundation Course
DMS42184 Page 9 of 90 Issue 1
ANS-UG0300110
Part Design Toolbars and Icons
There are eight main
toolbars within the Part
Design workbench: -
1. Sketch based Features
– creates geometric features
from sketches.
2.