DF5.9.4_Hot_Forming_Training_Tutorial.pdf

节选段落一：
Hot Forming
Training Tutorial
Version 5.9.4
Engineering Technology Associates, Inc.
1133 E.


节选段落二：
The default parameters for the hot forming are illustrated in the following figure.
Default parameters in hot forming
CONCLUSION
eta/DYNAFORM Application Manual 37
CONCLUSION
This concludes the training guide’s basic overview of eta/DYNAFORM 5.9.4.


节选段落三：
Hot Forming Training Tutorial
FOREWORD
OVERVIEW
TABLE OF CONTENTS
1. Hot Forming Analysis - B Pillar
Create an eta/DYNAFORM Database
I. Start eta/DYNAFORM 5.9.4
II. Open the Database
HOT FORMING SETUP
I. New Hot Forming Setup
II. General
III. Blank Definition
IV.